燃?xì)獍l(fā)電機組在運行和使用過程中需要注意一些事項。只有關注這些事項，才能讓發電機組更好地為人工作。那么在發生停電通知的情況下，如何保證燃?xì)獍l(fā)電機組的正常運行呢？

There are some matters needing attention in the operation and use of gas-fired generator units. Only by paying attention to these matters can the generator set work better for people. So how to ensure the normal operation of gas-fired generator units in the case of power failure notification?

如果接到停電通知，請?zhí)崆皽y(cè)試燃?xì)獍l(fā)生器的運行狀態，以確保停電時正常運行！啟動步驟如下：

If you receive the power failure notice, please test the operation status of the gas generator one day in advance to ensure normal operation in case of power failure! The starting steps are as follows:

1、檢查兩個水箱內的氣壓、潤滑油液位、冷卻液液位。

1. Check the air pressure, lubricating oil level and coolant level in the two water tanks.

2、將發電機從自動狀態轉為手動狀態；將開關從3點向左轉到12點到手動狀態；

2. Change the generator from automatic state to manual state; Turn the universal switch from 3 o'clock to 12 o'clock to manual state;

3、斷開左下方的發電機斷路器；將斷路器的手柄拉到底部以將其斷開；

3. Disconnect the generator circuit breaker at the lower left; Pull the handle of the circuit breaker to the bottom to disconnect it;

4、啟動發電機；12點至6點向左轉動開關，點火啟動機器；

4. Start the generator; Turn the universal switch to the left from 12 o'clock to 6 o'clock to start the machine;

5、機器開始運行后，請注意電壓400V，頻率50HZ，轉速1500轉，運行10分鐘。當水溫升至60℃時，將開關從6點方向轉到9點方向，即為待機運行狀態。5機器會在幾分鐘后自動停止；

5. After the machine starts to run, please note that the voltage is 400V, the frequency is 50Hz, the speed is 1500 rpm, and the machine will run for 10 minutes. When the water temperature rises to 60 ℃, turn the universal switch from 6 o'clock to 9 o'clock, which is the standby operation state. 5 the machine will stop automatically in a few minutes;

6、測試完畢，請將斷路器恢復到合閘狀態，將轉換開關從沼氣發電機組9點鐘方向撥到3點鐘方向，到時機器會自動啟動。電源被切斷。

6. After the test, please return the circuit breaker to the closing state, and turn the universal transfer switch from 9o'clock to 3o'clock of the biogas generator set, when the machine will start automatically. The power supply is cut off.

如果發電機在外部電源呼叫后無法自動關閉：

If the generator fails to shut down automatically after an external power call:

1、手動停機，直接將轉換開關從3點方向轉到12點方向，即停機；

1. Manual shutdown: directly turn the universal change-over switch from 3 o'clock to 12 o'clock, i.e. shutdown;

2、打開低壓配電柜。上面的開關是電源開關，下面是照明開關。照明開關左側有一個小三角形。請戴上絕緣手套，向上轉動三角輪。聽到聲音后，它被關閉了。門傳輸；

2. Open the low-voltage distribution cabinet. The upper switch is the power switch, and the lower switch is the lighting switch. There is a small triangle on the left side of the lighting switch. Please wear insulating gloves and turn the triangle wheel upward. After hearing the sound, it was turned off. Door transmission;

用戶需注意，關好柜門，將發電機從手動狀態轉為自動狀態，恢復生產。

Users should pay attention to closing the cabinet door, changing the generator from manual state to automatic state, and resuming production.

此外，每周啟動發電機前，應檢查發電機的潤滑油位和兩個水箱的冷卻液位。禁止低油位、低冷卻液位運行燃?xì)獍l(fā)發電機組，以免損壞發電機，如潤滑油位。如果低于下刻線，請及時添加潤滑油，冷卻液主要加滿。每次檢查時，請檢查冷卻液液位和油位。例如停止運行后待機溫度下降時，請將發電機本體上的油漬擦掉，以免長時間難以處理，影響美觀。

In addition, before starting the generator every week, check the lubricating oil level of the generator and the cooling liquid level of the two water tanks. It is forbidden to operate the gas generator at low oil level and low cooling level to avoid damaging the generator, such as lubricating oil level. If it is lower than the lower scribed line, please add lubricating oil in time, and the coolant is mainly full. Check the coolant level and oil level each time. For example, when the standby temperature drops after the operation is stopped, please wipe off the oil stains on the generator body, so as not to be difficult to handle for a long time and affect the appearance.

以上就是問題解答的相關內容了，希望能夠幫助到大家，如對這一問題還存在任何疑問，都?xì)g迎關注我們網站http://www.hdlelisa.com并咨詢我們的工作人員，將竭誠為您服務。

The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://www.hdlelisa.com And consult our staff, will serve you wholeheartedly.