如遇接到停電通知時，請?zhí)崆皽y(cè)試燃?xì)獍l(fā)電機組運行狀態，確保停電時正常運行！啟機步驟如下：

In case of receiving the notice of power failure, please test the operation status of the gas generator set one day in advance to ensure normal operation in case of power failure! The starting steps are as follows:

1、檢查燃?xì)鈿鈮毫Α?rùn)滑油油位、兩水箱的冷卻液液位，

1. Check the gas pressure, lubricating oil level and coolant level of the two water tanks,

2、將發電機有自動狀態轉換至手動狀態；將轉換開關由3點方向左旋轉至12點方向?yàn)槭謩?dòng)狀態；

2. Switch the automatic state of the generator to the manual state; Turn the universal change-over switch from 3 o'clock to 12 o'clock to manual;

3、斷開左下方發電機斷路器；將斷路器手柄扳至下方極為斷開；

3. Disconnect the lower left generator circuit breaker; Pull the handle of the circuit breaker to the lower pole to disconnect it;

4、啟動發電機；將轉換開關由12點方向向左旋轉至6點方向即為點火啟動機器；

4. Start the generator; Turn the universal change-over switch from the 12 o'clock direction to the left to the 6 o'clock direction to start the machine;

5、機器啟動運行后請仔細關注電壓400V,頻率50HZ，轉速1500轉，運行10分鐘待水溫上升至60℃時，將轉換開關由6點方向旋轉至9點方向即為待機運行狀態，5分鐘后機器會自動停機；

5. After the machine starts and runs, pay close attention to the voltage of 400V, the frequency of 50HZ, and the speed of 1500 revolutions. After 10 minutes of operation, when the water temperature rises to 60 ℃, turn the universal change-over switch from the 6 o'clock direction to the 9 o'clock direction, which is the standby operation state. After 5 minutes, the machine will automatically stop;

6、測試結束后，請回復斷路器合閘狀態，將轉換開關由發電機組9點方向旋轉至3點方向，待停電時會自動啟機

6. After the test, please return to the closing state of the circuit breaker, turn the universal change-over switch from the 9 o'clock direction of the biogas generator set to the 3 o'clock direction, and the machine will start automatically when the power is cut off

如遇外電來電后發電機不能自動停機操作：

If the generator cannot stop automatically in case of external power:

1、手動停機發電機，直接將轉換開關由3點方向轉至12點方向，這是發電機停機；

1. Stop the generator manually, and directly turn the universal change-over switch from the 3 o'clock direction to the 12 o'clock direction, which is the generator shutdown;

2、打開低壓配電柜，上方開關為動力開關，下方為照明開關，在照明開關左邊有一小三角論，請操作人員員戴上絕緣手套，向上轉動三角輪，待聽到響聲后即已經合閘送電；

2. Open the low-voltage power distribution cabinet. The upper switch is a power switch, and the lower switch is a lighting switch. There is a small triangle on the left side of the lighting switch. Please wear insulating gloves and turn the triangle wheel upward. After hearing the noise, the switch has been closed for power transmission;

需要用戶注意，關閉柜門，將發電機由手動狀態轉至自動狀態，恢復生產。更多相關設備事項就來我們網站http://www.hdlelisa.com進行咨詢！

Users should pay attention to that, close the cabinet door, turn the generator from manual state to automatic state, and resume production. More related equipment matters will come to our website http://www.hdlelisa.com Consult!